Add Support Beams to Rear Access Dock

Make sure every floorboard is clearly marked in order (1-2-3-4, etc.) before removing anything.

Remove all floorboards and set them aside carefully. Confirm that all long beams are fully exposed.

Temporarily screw the existing beams together so their alignment stays the same once bolts are removed.

Remove the bolts from the beams but keep all washers, as we need them.

Position the 3 new beams so each existing beam gets paired�creating a 3-beam stack at each location.Bolt the beams together to hold them in place in correct alignment. (Martin do this)

Use the existing hole that goes through the two original beams as a drill guide. Run the drill bit through that hole to open the path through the new third beam. Repeat for each hole

Cut the left over wood from transversal beams (let Martin do this)

using new screws re position the floor boards covering the beams.

paint the dock green