Run Water Maker on Cat 51 task card

Make sure the hose is pointing somewhere where water does not damages anything

Check seacock for watermaker intake is open.

Confirm 12 V breakers and main power are on.

Inspect strainer for marine growth debris clean if needed.

Check the pre-filters for excessive dirt or pressure drop.

Turn on the feed pump and high-pressure pump in the proper sequence per manufacturer.

Observe pressure gauge typically should stabilize around 800�900 psi

Run the system for 15�20 minutes, or until product water is running clean.

Smell the product water and visually check clarity. It should be clean, odorless, and fresh.

Check TDS meter (if installed) � should be below spec (usually < 500 ppm for drinking).

Listen for unusual pump noises or cavitation.

verify that there are no leaks in hoses and fittings.